AMBISONIC LANDSCAPE COLLECTION™
19
•
Use 1 separate wire run for:
Subwoofer units of Bollards
•
Use another separate wire run for:
Satellite units of Bollards
•
The subwoofers and satellites will be run in
PARALLEL for 70V WIRING SETUP.
This means the positive connection on the amplifier will be connected to the positive
connection on speaker 1, 2, 3, etc. The negative connection will be connected to the
negative connections on the speakers as well. This can be accomplished with a single pair
of wires in a “daisy chain” where the amplifier is at one end and the speakers are connected
consecutively.
• If desired, you can also wire in a star pattern where each speaker is directly wired back to
the amplifier.
Please
contact the Ambisonic/Origin Acoustics Customer Service for
any inquiry regarding these setups.
AMPLIFIER OF CHOICE
The D3200 amplifier from Ambisonic was specifically designed
to drive Ambisonic’s speaker systems. In 70V, it is the recommended amplifier for Sub
control and DSP for best performance.
The D3200 offers EQ and crossover presets specifically tailored for the Ambisonic Bollard.
The presets have active crossovers that remove the bass from the satellites and send that
bass only to the subwoofers. This controls more effectively how the subwoofer interfaces
with the satellites: permitting you to control the subwoofer-to-satellite balance. The digital
signal processing or [DSP] also shapes the sound between both subs and satellites to
create optimum performance.
RECOMMENDED D3200 AMP
10. 70V WIRING SETUP: INSTALLATION GUIDANCE
