Cross section
Reservoir
Pump
Hose
Plate
Washer
Nuts
Rod / thread
Reservoir lid
Bracket
x 4
x 16
x 8
5. Connect hose to the pipe inlet of
the feature. Note: cut the hose up to connect
adjustor. Add flow adjustor on the hose.
Connect the other hose from adjustor to pump.
Note: Splashing may occur.
Please adjust the flow adjustor
to minimise splashing. Or drill
more holes to allow water to run
down quickly back into the reservoir.
6. Place pump in the reservoir, add support
legs (which holds the weight of the feature)
Fill the reservoir up with water. Make sure
the pump is submerged. Wire the pump up
into 3 pin plug (10m cable).
7. Place the feature (bolted onto the lid)
on top of the reservoir.
8. Decorate by placing pebbles (not included)
around the reservoir lid.
Reservoir
Add flow adjustor
in the middle.
Insert
