1.
Pressure Altitude
2.
Pressure Trend (up, down, steady)
3.
Relative Pressure
4.
Forecast icon (sunny, partly cloudy,
cloudy, rainy)
5.
Temperature degrees
6.
Altitude units of measure (Feet)
7.
Altitude units of measure (Meters)
8.
Pressure units of measure (hectopascals)
9.
Pressure units of measure (inHg)
10.
Temperature units of measure (degC or
degF)
11.
Low battery indicator
12.
Compass mode
13.
16 point compass rose
14.
Secondary parameter display
15.
Sea level pressure
16.
Barometric pressure mode
17.
AM/PM time indicator (P = PM)
18.
Primary parameter display
19.
Altitude rate of change units of measure
(ft/min or m/min)
4.
Set Mode
To enter the SET Mode, press and hold the
MODE
button for 3 seconds. To exit the SET mode and
return to the NORMAL mode at any time, press and hold the
MODE
button again for 3 seconds. The
SET mode will also automatically exit after 30 seconds of inactivity, and return to the NORMAL
mode.
The following sections describe the settings available in the Set Mode. To skip any step, press the
MODE
button again.
Set Modes:
Forecast -> 12/24 Hr -> Hour -> Minute -> Month -> Day -> Temperature Units -> Pressure Units ->
Altitude Units -> Compass Magnetic Declination -> Compass Calibration
4.1
Forecast Mode
The current forecast will begin flashing. Press the
ALTI
button to set the forecast icon to the current
weather conditions, as defined below:
Condition Icon
Sunny
Partly Cloudy
Cloudy
Rainy
Press the
MODE
button to continue to the next step.
4.2
12Hr/ 24Hr Format
The hour format will begin flashing. Press the
ALTI
button to toggle between 12 Hour (AM/PM)
and 24 Hour format. Press the
MODE
button to continue to the next step.
4.3
Time
The hour will begin flashing. Press the
ALTI
button to advance the hour. Note that in the 12 hour
mode, the
P
icon will be displayed to designate PM (no icon is present for AM). Press the
MODE
button to set the minute.
Version
1.1
©Copyright
2011,
Ambient
LLC.
All
Rights
Reserved.
Page
4
