Version 1.0
©Copyright 2011, Ambient LLC. All Rights Reserved.
Page 2
2.2 Remote Thermometer Sensor Set Up
Note:
To avoid permanent damage, please take note of the battery polarity before inserting the
batteries.
Pull down on the battery door to open the battery compartment, as shown in
.2. Insert two
fresh AAA batteries (with the negative terminal of the battery in contact with each spring). Lithium
batteries are recommended for cold weather environments. Slide the top lip of the battery door into
the battery compartment guide and snap the bottom battery door bracket into place. The LED shown
in
.1 will light up (visible through the plastic).
Figure 1
2.3 Display Console Set Up
Note:
To avoid permanent damage, please take note of the battery polarity before inserting the
batteries.
Move the remote thermometer at least 5’ away from the display console (if the sensor is too close, it
may not be received by the display console). Remove the battery door on the back of the display.
Insert two AA (alkaline or lithium) batteries in the back of the display console, as shown in Figure 2.
All of the LCD segments will light up for a few seconds to verify all segments are operating properly.
Replace the battery door, and fold out the desk stand and place the console in the upright position.
The console will instantly display indoor temperature. The outdoor temperature will display dashes
or --.-, then update on the display within a few minutes.
If the remote sensor does not update, please reference the troubleshooting guide in Section 6.