Version 1.2
©Copyright 2018, Ambient LLC. All Rights Reserved.
Page 3
2.4
Display Console Set Up
1.
Move the remote thermometer(s) about 5 to 10’ away from the display console (if the sensor
is too close, it may not be received by the display console).
2.
Remove the battery door on the back of the display, as shown in Figure 2. Insert one AA
(alkaline or lithium, avoid rechargeable) battery in the back of the display console.
Figure 2
1
Suspension eye for wall hanging
2
Desk Stand
3
°C / °F button
4
High / Low Record button
5
Battery Compartment
6
Battery Compartment door
All of the LCD segments will light up for a few seconds to verify all segments are operating properly.
3.
Replace the battery door, and fold out the desk stand and place the console in the upright
position.
The console will instantly display indoor temperature and humidity. The remote
temperature will update on the display within a few minutes.
While in the search mode, the reception search icon
flash.
If the remote does not update, please reference the troubleshooting guide in Section 7.
