Version 1.0
©Copyright 2015, Ambient LLC. All Rights Reserved.
Page 7
the battery.
If you want to select the same charge current for multiple batteries at the same time, it is best to insert
all four batteries into the charger, re-power the charger again, then press
CURRENT
, and all batteries
will charge at the same current.
If a different working mode or display mode is desired for a particular slot, press the
SLOT
button to
select the desired slot and then press
MODE
or
DISPLAY
to change the mode.
The charging current can be adjusted between 200mA, 300mA, 500mA ,700mA, and 1000mA.
If only slots 1 and/or 4 are used for charging, the charging current can be further adjusted to 1500mA
and 2000mA.
The following table provides the ideal configuration for two battery charging as well as the charging
current for two and four battery operation.
Battery configuration
Maximum charging current per slot
1000 mA
2000mA
The following table provides the maximum charging current for several battery configurations.
Slot 1
Slot 2
Slot 3
Slot 4
2000 mA
--
--
--
2000 mA
--
--
2000 mA
--
1000 mA
1000 mA
--
1000 mA
1000 mA
1000 mA
1000
mA
NOTE:
When a high impedance battery (over 2500 milliohm) is loaded onto the charger, due to its
high internal impedance, the displayed charging current may be much less than your pre-selected
charging current. When this occurs, it does not indicate the charger is defective. It does require longer
charging times.
5.5
Display Modes (DISPLAY button)
Press the
DISPLAY
button to change the display mode selection for all four battery slots.
If you wish the change the mode for a particular slot, press the
SLOT
button until the desired slot is