50D0035 Rev 1 July 2002
Page 4 of 5
Ambient Technologies
A Division Of
Monessen Hearth Systems
WA
RNI
NG
Do not use two (2) or more remote control systems in the same area with the same dip switch
settings, as they will communicate with each other. This may cause the appliances to
malfunction.
OPERATIONS:
Transmitter:
General:
The RCB is an On/Off remote control.
The transmitter will operate the remote receiver from 1foot to a
maximum of 30 feet. The operational range is reduced when
batteries are low or when the receiver is inside a metal enclosure.
Initial start up:
1.
After initial power up, the transmitter is ready for use.
Manual Mode:
1.
Press the On button once to turn on the appliance. Press
the OFF button to turn it off.
Low-battery detection:
1.
When the battery voltage drops to a certain level, the LED on the transmitter will blink until the battery
expires. Change the battery before the battery is too weak for normal operation.
TURN THE UNIT OFF
BEFORE REPLACING BATTERIES.
Receiver:
Slide Switch:
1.
ON position: the system will remain on until the slide switch is placed in the OFF or RS position.
2.
RS position: the system will only operate if the remote receiver receives a signal from the transmitter.
3.
OFF position, the system is off. The slide switch should be placed in the OFF position if you will be away
for an extended period of time. If the remote receiver is mounted out of children’s reach, the OFF position
also functions as a safety device by both turning the system off and rendering the receiver inoperable.
TESTING YOUR NEW REMOTE CONTROL SYSTEM
1.
Connect the wiring terminal to the appliance. Refer to the appropriate Homeowner’s Manual for proper
wiring connections to the appliance.
2.
Light your gas appliance following the appliance lighting instructions that came with the appliance.
Confirm that the pilot light is on; it must be in operation for the remote control to operate the main gas
valve. Appliance control knob must be in the ON position. Appliance ON/OFF switch must be in OFF
position.
3.
Slide the 3 position button on the remote receiver to the ON position. The main gas flame should ignite
4.
Slide the button to OFF. The flame should extinguish (the pilot light will remain on).
LED
