Unscrew screws Cover removal
SIM card insert Battery connection
Mounting recommendations
•
Connecting wires
1. Wires should be connected while the module is not plugged in.
2. Wires should be fastened to the other wires or non-moving parts. Try to avoid heat emitting and
moving objects near the wires.
3. The connections should not be seen very clearly. If factory isolation was removed while connecting
wires, it should be applied again.
4. If the wires are placed in the exterior or in places where they can be damaged or exposed to heat,
humidity, dirt, etc., additional isolation should be applied.
5. Wires cannot be connected to the board computers or control units.
•
Connecting power source
1. Be sure that after the car computer falls asleep, power is still available on chosen wire. Depending
on car, this may happen in 5 to 30 minutes period.
2. When the module is connected, measure the voltage again to make sure it did not decrease.
3. It is recommended to connect to the main power cable in the fuse box.
