TEMPERATURE button:
Turns heater
on and off.
NOTE:
Press the button for 5 seconds, the
temperature setting will switch from
℃
to
℉
. Same way from
℉
to
℃。
1.
Press once:
Touch panel indicator
becomes active.
2.
Press again:
until desired setting is
‘ Reached. Digital display shows
setting circles as below:
LED Ember light button ( 1 ):
Changes
the color of the bottom (ember) lighting.
NOTE:
Ember color effect stays on until
power button is turned off.
1.
Press once
. Ember color effect is
changed.
2.
Press again.
until desired setting is
reached, in total a cycle of 10 colors.
LED Bottom light button ( 2 ):
Makes the
color on bottom (ember) lighting effect
automatically cycle (flash) through color
options.
NOTE:
Ember color effect stays on until
power button is turned off.
1.
Press once
. Ember color effect is
changed automatically.
2.
Press again.
Ember color effect
flashes and is changed automatically.
Temperature Limiting Control
This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe
temperature, the heater will automatically turn OFF. To reset:
1. Unplug the power cord from the outlet.
2.
Turn the ON/OFF switch on the CONTROL PANEL to OFF.
Wait 5 minutes.
3. Inspect the fireplace to make sure no vents are blocked, or clogged with dust or lint. If they are,
use a vacuum to clean the vent areas.
4. With the POWER switch in the OFF position, plug the power cord back into theoutlet.
5.
If the problem continues, have your outlet and wiring inspected by a professional.
Remote Control Battery Information
•
This remote control uses CR2025
battery (included).
•
Instructions for battery installation are on the Remote Control batterycompartment.
NEVER
dispose of batteries in
fire.
Failure to observe this precaution
may result in an
explosion
. Dispose of batteries at your local hazardous material processingcenter.
NOTICE
To improve operation,
aim
the remote control at the front of the fireplace.
DO NOT
press the buttons too quickly
. Give the unit time to respond to each command.
NOTICE
When the fireplace is first turned on, a slight odor may be present. This is normal
and should not occur again unless the fireplace is not used for a long period of
time.
