Part 2 – Attaching the Projector to the Mount
XXXX-20181008
1
Swivel adjustment can be made by simply turning your
projector in the desired direction (see Fig. 16).
OPERATION AND ADJUSTMENT
Examine the mounting holes on
the back of your projector to
determine the extension arm
needed or not.You may need to
remove the fixing screw on the
extension arm to shorten the
extension arm for smaller
projector(see Fig. 11).
1
Hook the mount base with your projector attached onto the
mount body. Tighten the M5 x 10 screws
(
E
)
on the sides of
the mount base to hold it in place (see Fig. 15).
1
Attach your projector to the mount arms as shown using the
appropriate screw from the hardware kit (C, D, F and G) (see
Fig. 13)
．
3
Attach the mount arms to the mount base as shown using the
M6 x 12 screws (G) and M6 washer (K) from the kit. Attach one
mount arm into each slot in the mount base (see Fig. 12).
Leave the screws loose enough so that the arms can be
moved when attaching the projector.
2
Tighten the M6 x 12 screws (G) used to attach the arms to the
mount base in step 1 (see Fig. 14).
NOTE:
If you cannot find a screw from the
provided hardware kit that fits, consult the
manufacturer of your display for the
proper size.
Part 2 – Attaching the Projector to the Mount (continued)
Part 3 – Assembling the Mount
4
2
3
Attach the M5 large washer (L)
to the Mount Body using the M5
x 10 screw (E) from the kit (see
Fig. 7). Leave the screw loose
enough so that the mount can
be hooked onto the mount
body.
After you have determined your
desired Projector location, Place
the ceiling plate over the joist
and mark two locations for
securing the plate to the ceiling.
4
5
6
Set the ceiling plate aside and
drill two holes 3”(76mm) deep
using a 5/16”(or 8mm) size drill
bit at each marked location (see
Fig. 8).
Insert concrete anchors (B) into
each hole so that it is flush with
the concrete surface. A hammer
can be used to lightly tap the
anchors into place if necessary
(see Fig. 9).
Install the Ceiling Plate using
two Lag Bolts (A) in the “A” and
“B” holes. Do not over tighten lag Bolts (see Fig. 10).
Part 1B – Mounting to the Ceiling (Concrete)(continued)
(G)
(C or D or F)
(I or H)
C
I
D
I
F
H
(E)
(A)
360°
2
Tilt adjustments can be made by loosening the screws on
both sides of the ceiling plate and mount base, moving the
projector to the desired angle, and then re-tightening the
screws (see Fig. 17).
3
Periodically clean your mount with a dry cloth. Inspect all
screws and hardware at regular intervals to ensure that no
connections have become loose over time. Re-tighten as
needed.
±15°
±15°
Fig. 8
Fig. 9
Fig. 10
Fig. 11
(G)
(K)
Fig. 12
Fig. 13
Fig. 14
Fig. 15
Fig. 17
Fig. 16
(E)
(L)
Fig. 7
