NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment causes harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
5.
6.
If the paper shredder will not start, please check the following:
1.
Is the machine plugged in correctly?
2.
Is the switch set to the “READY”( ) position?
3
. Is the machine jammed?
4.
Is the bin full of shredded paper?
5.
Has the motor overheated?
6.
Is the shredder bin fully pushed in?
Troubleshooting
Slide the switch to OFF ( ). When not in use,
it is recommended that you keep the shredder
turned off to save power. It is also a good
practice to switch it to the off position before
emptying the bin.
A jam may happen if you shred over the maximum
sheet capacity. Slide the switch to REVERSE ( ).
The jammed paper will be reversed back. Once
the jam is cleared, slide switch back to READY ( ),
the shredder is ready for normal operation.
Plug in the shredder. Slide the switch to READY( ),
the shredder is in ready status and you can shred
paper and other media.
Slide the switch to FORWARD( ). The shredder
will start operating in manual feed mode.
Occasionally when paper is so jammed that it
will not come out using the reverse function
described above, you can switch between
reverse and forward. Take care not to switch too
quickly between reverse and forward as this
can damage the shredder.
Ready
Reverse
Forward
Off
Shredder will overheat if used continuously for
approximately 9-12 minutes. It will stop
working and overheat indicator light will turn
on. Allow shredder to cool down. You can
resume shredding once overheat light turns off.
Make sure to empty the pull-out waste basket
regularly to avoid shreds from jamming in the
cutters.
Overheat
Empty the wastebasket
Instruction of switch, button and indicator