O
peratOr
’
s
M
anual
AMAZING MACHINERY
2288 Gunbarrel road, Suite 111-151
ChattanooGa, tenneSSee 37421
Phone: 1-800-504-7435 Fax: 1-800-504-7436
p
age
FILL FUEL TANKS IN OPEN AREA AWAY FROM OPEN
FLAMES OR SPARKS. USE ONLY CLEAN FUEL VOID OF
WATER AND CONTAMINATES.
Following the requirements below will insure a successful installation.
Install group 24, 750- 850 cold cranking amp battery.
Red cable is attached to positive terminal.
Check fuel oil and fill with diesel #1, diesel #2, kerosene or #1 home heating oil.
Check the gasoline tank and fill with a good grade of gasoline.
Check the engine oil level and fill with SAE 10W40 if needed.
Check the pump oil level and fill with SAE 30w non-detergent oil if needed.
Connect water hose to the water inlet connection located on the machine.
Turn on water and check float tank for water level.
Start gas engine and continue until water discharges from coil
Stop engine and connect high pressure hose to the outlet.
Restart engine and open trigger gun control to flush system until water is clear.
Install water nozzle at the end of wand, making sure it is clear of any obstructions.
Turn burner switch to “ON” position and check for burner ignition.
Check for leaks in the system and cycle trigger gun to insure bypass is adjusted correctly.
Repair and leaks nad correct unloader adjustment if needed.
If unit is hot, run until unit is cool then shut down machine.
�
WARNING
inStallation inStruCtionS