7
8
P
CALIBRATING THE ASC-2400
NOTE: Your ASC-2400 comes pre-calibrated out of the box so you are ready to fly.
After several crashes and shocks to your gyro sensors, you may notice that your drone is drifting and cannot
hold its center position while hovering as well as it used to.
This most likely means that you need to recalibrate your ASC-2400. Please follow the simple instructions
below.
1. Place the ASC-2400 on a very flat level surface.
2. Make sure the ASC-2400 is turned on and that the controller is synced (refer to syncing pg 4). Do not start
the blades! Instead move both the throttle and control stick down and to the right hand bottom corner
(see diagram P). If successful you will see the lights on the drone rapidly flash and stop. Once the lights
stop flashing you have completed your calibration and are ready to fly again!
TROUBLE SHOOTING
: If you do not see the lights flash, remove the battery from the drone then turn off your
controller and start over. Always make sure to put your battery in before turning on your controller. Push the
left throttle stick all the way up and then down touching the top and bottom of the controller. When you
hear the beep the ASC-2400 is re-synced to the controller and you are ready to calibrate.
NOTE: To exit the stunt roll mode without flipping simply press the stunt button again and the
beeping sound will stop indicating you have exited “stunt mode”
HOW TO PERFORM 360º STUNT ROLLS
Performing 360º stunt rolls with the ASC-2400 is as easy as 1-2-3:
1. Hover the ASC-2400 in a still position making sure that you have at least 6 feet of clearance above and
below the drone. Set the speed settings to mode 2 or 3 (the ASC-2400 cannot perform the stunt roll in
speed setting 1).
2. First press the 360 stunt button on the right top side of the controller and you will enter the “stunt roll
mode” which is indicated by a rapid beeping sound (see diagram Q).
3. Next, using the right control stick, push directly to the right for a “right side roll” or directly to the left for
a “left side roll” (see diagram R). Remember to always use caution when performing stunts.
ADJUSTING THE TRIM
NOTE: The ASC-2400 is already properly trimmed and calibrated right out of the box and should not require
any trim adjustments before flying. Some more experienced pilots may want to adjust trim settings for
their style of flying. After several crashes you may need to adjust trim settings for the ASC-2400 to be more
balanced.
NOTE: When using the trim buttons you will beeping sounds. A short “beep” indicates “one trim
position movement” A long Beep indicates that you have reached the center trim position. When
there are no longer beeps, you have reached the maximum trim position for that particular
setting. If this happens and your Drone is still not stable, we suggest you re-sync your drone and
re-calibrate on very flat surface (see recalibrating your drone on next page)
EMERGENCY STOP:
press the “
speed setting button
” and “
stunt button
” simultaneously to stop the
drone blade from spinning. Use this anytime you lose control of your drone.
M
N
Forward/Backward Trim
• If your ASC-2400 drifts forwards or backwards while
in the air, counter the movement by using your
forward /backward trim buttons (see diagram M).
Bank Right/Left Trim
• If your ASC-2400 drifts to the left or right while in the
air, counter the movement by using your left / right
trim buttons (see diagram N).
Spinning/Rotating Trim
• If your ASC-2400 spins either left or right while in the
air, counter the rotation by using your left and right
rotational trim buttons (see diagram O).
O
360˚Stunt Roll Button
Q
R
