If you’re still encountering difficulties downloading the ASC-2080 App, please contact our
customer service department at www.amaxbrands.com
* Apple® devices require the use of iOS 10.0 or higher.
ANDROID™ devices require the use of OS 4.2.2 or higher.
Apple
®
iOS
Android OS
ICON
http://qr03.cn/Bn4HaO
http://qr03.cn/FqBpEP
VA-1000
11
12
PROBLEM
POSSIBLE CAUSE
POSSIBLE SOLUTION
1.
Power switched off 1.
ASC-2080 the ON/OFF switch to ON
No Power
2. Polarity is reversed
2. Make sure all batteries are installed
3. Batteries may be low or in need of charging correctly (see diagram A)
3. Replace batteries
1. Remote is switched off 1.
ASC-2080 the ON/OFF switch to ON
Drone Not
2. Battery power in remote is too weak
2. Replace remote batteries
Responding
3. The remote is not properly synced
3. Re-sync the remote
4. Out of control range
4. Do not fly beyond 200 feet
Drone Won’t
1. Rotor speed too slow
1. Push throttle lever forward
lift off
2. Drone not fully charged
2. Recharge your ASC-2080
3. Obstruction of rotors
3. Check rotors for hair or other obstructions
TROUBLESHOOTING YOUR ASC-2080
Drone Spins, can
not be trimmed
Rotor deformation or bad motor
Replace the damaged rotor (You may
need to consult with a customer service
personnel)
Drone Tilt to one
direction
Drone did not calibrate properly
Restart the Drone and controller, properly
calibrate it on a flat level surface
Altitude Hold
height is not
stable, the drone
continues to move
up and down
without locking
into position
Drone vibrates too much
Check the propeller deformation
CAMERA VIDEO AND PHOTO STREAMING SETUP
Your ASC-2080 comes equipped with an on-board digital camera that takes both video and still photographs and
streams them to your mobile device.
WHAT YOU WILL NEED TO GET STARTED USING YOUR CAMERA
1. One Apple or Android Smart phone* (Phone not included).
2. The ASC-2080 App successfully downloaded and installed on your mobile device.
Note instructions on using the App are in the application tutorial
3. To Download the ASC-2080 App, scan the appropriate QR code below which will link to the App on either
the Android Play Store or Apple Store. If you are not able to scan the QR code, manually enter the web
address located under the appropriate QR code for your phone.
4. After the ASC-2080 App is installed, it should create an icon on your screen (see icon below). Click the icon
to run the App and make sure that it has installed correctly on your device. If not, please delete and repeat
the process again.
5. Follow the “TUTORIAL” for instructions on connecting/pairing your ASC-2080 drone to the App and using
the App for recording film and still photos.