Amate Audio KT12, Руководство пользователя, Страница: 5 / 10

KT12 Apr 2016
5
Amate Audio
Fig.6. Bi-amplified with subwoofer configuration (option 2)
WARNING!!!!: In order to allow a bridge connection between cabinets, each one of
them has been provided with two Speakon connectors that allow the Input / Output
function indistinctly. Terminal Pins +1/-1 must be always used, disregarding the +2/-2
which are not internally connected.
3. MOUNTING AND PLACEMENT
For a proper installation of the acoustic cabinet systems, it is strongly recommended
to carefully read the following advices.
3.1. Placement
The Full Range cabinets should be located in a high
position (between two or three meters), slightly inclined to
the audience. If the loudspeakers are located too low, the
listeners at the end of the room will not hear a good sound
quality.
Fig.7. Flying placement
It is advisable to locate the subwoofer units on the floor as they can take advantage
of the so-called “floor-effect”, thus increasing the response in the low frequencies. If
possible, place the subwoofers under the same acoustic axis used for the satellites.If
the above option can not be carried out, then they should be placed in an
intermediate point between the left and right channels
3.2. Asymmetrical and rotatable horns
The KT12 model incorporates an asymmetrical dispersion horn which will optimise
coverage either in horizontal or vertical position.
To rotate the horn, unscrewed the frontal grille, and then, unscrewed the four fixing
screws of the horn. Rotate it 90 degrees taking care of the wires. Screw the horn
again and finally place the frontal grille in its right position.