Amano PIX-15, Руководство пользователя

Страница: 9 / 12

Amano Cincinnati, Inc. (Mon. - Fri. 8:00 - 5:00 PST) 1-800-253-9836
Page 7
Replacing the Ribbon
1. Insert the key into the key hole (see page 2
for keyhole location) and turn the key.
2. Grab the cover on both sides and lift to
remove it.
3. Pull the two catches (B) upward and hold
them with your index and middle fingers.
Remove the ribbon cassette.
Note : If the print mechanism is in the down position and a piece
of paper cannot be inserted, press the RESET button to move the
carriage up. This will make the ribbon installation easier.
4. Insert a new ribbon between the ribbon guide (C) and the printer
head (D).
5. Turn the knob on the cassette clockwise one turn to take up any
slack in the ribbon.
6. To replace the cover, remove the key, align the lower back corners
to the base of the clock and snap the cover down into position.
Mounting the Clock
1. Remove the cover as per the instructions above.
2. With the clock facing you, remove the mounting bracket by pulling
the top tabs (A) towards you, and then pushing the tabs down
(see below).
3. Securely mount the PIX mounting bracket on the wall using three
#10 wood screws or equivalent.
4. Place the PIX-15 on the Mounting Bracket by sliding the top tabs
into the slots on each side of the case. Push the PIX-15 back and
down against the Mounting Bracket until the PIX-15 snaps into
place. Be careful not to pinch the power cord with the bracket.
Installing the cover will secure the PIX-15 to the mounting bracket.