Amano American SANDERS FloorCrafter, Руководство оператора

Страница: 7 / 40

7
CAUTION: This machine will operate only on AC frequency and on electrical voltage shown on the motor nameplate. Make
sure you have the correct frequency and voltage before connecting the power cord to an outlet. The machine has
a plug as shown below.
DANGER: Electrocution could occur if the machine is exposed to water or rain. Keep the machine in a dry building.
DANGER: Electrocution could occur if machine is improperly connected to the electrical system. To prevent possible electric
shock, always use a 3 -wire electrical system connected to an electrical ground. For maximum protection against
electrical shock, use a circuit that is protected by a ground fault circuit interrupter. Consult your electrical
contractor.
DANGER: Electrocution could occur if the ground pin is tampered with in any way. Do not cut, remove, or break the ground
pin. Do not try to fit a three-terminal plug into a receptacle or connector body other than a three-plug receptacle
or connector body. If the outlet does not fit the plug, consult your electrical contractor.
DANGER: Electrocution could occur if the machine is used with a damaged plug or power cord. If the cords or plugs are worn
or damaged in any way, have them replaced by an authorized service person or electrician.
If motor appears to labor or takes a considerably longer time to come up to speed, reduce sanding pressure.
Machine Specifications
Introduction
The FloorCrafter can be used on a variety of surfaces. It is an ideal tool for wood flooring maintenance and restoration work.
230V Electrical Connection Instructions
This machine must be connected to an electrically ground circuit in order to pro-
tect the operator from electric shock. This machine has an approved power cord
with three conductors as well as a plug with three terminals. Connect the plug into
a three holed receptacle. For maximum protection against electric shock, use a
circuit that is protected by a ground fault circuit interrupter.
Extension Cords
Use only an approved three-pronged extension cord with two main conductors
and one earthing conductor. This machine is equipped
with a power cord. When greater range is needed follow the table
to determine cable gauge of additional footage. Refer to the
chart to the right for extension cord information.
EN
Part # 07239A
Model FloorCrafter 8
Electrical Requirements 240V~, 50Hz / 11.8 A, 2.2kW
Sound Emission (Lpm)* 96.2 dB(A)
Vibration 2.88 m/s
2
rms
Motor 3 Hp, (2.2 kW) Induction
Contact Wheel Rate 2042 rpm
Abrasive Rate 3750 ft/min (624 m/min)
Abrasive Size 29
½
” x 7
⅞
” (75 cm x 20 cm)
Fan Flow Rate 195 CFM (5,5 CMM)
Drum Settings 80 lbs., 70lbs., 60 lbs. (36 kg, 32 kg, 27 kg)
Overload Protection Magnetic Circuit Breaker
Electric Cable 12,2 m, H05VVF3G4.0 C13- Plug
Operating Controls Adjustable Lever/Grip
Leveling Controls Externally Adjustable
Operating Wheels 80 Durometer Clear Urethane
Weight 204 lbs. (92,5 kg)
Dimensions 35” x 13
¾
” x 38
¾
” (89 cm x 35 cm x 98 cm)
Source Voltage 0-30 m 30-75 m
230 4.0 sq mm 6.0 sq mm
Meter/Wire Guage (Stranded Copper)