11
Troubleshooting
Problem
Possible Cause
Solution
No Power.
Check power supply and connection.
Interlock not depressed.
Depress Interlock before activating control lever.
Defective switch / Bad Connection
Contact an authorized American Sander Technology Dealer.
Low voltage from excessive length or
undersized extension cord.
Use a 14 Ga extension cord, not to exceed 50’ length.
Defective start switch.
Contact an authorized American Sander Technology Dealer.
Defective motor.
Contact an authorized American Sander Technology Dealer.
Eliminate extension cord. Locate power source closer to work site.
Have voltage checked by a qualified electrician.
Bad Connection.
Contact an authorized American Sander Technology Dealer.
Defective Motor.
Contact an authorized American Sander Technology Dealer.
Handle feels loosely connected to
machine base.
The latches have loosened up.
To tighten latches, loosen the lock nut, screw in the latch hook and then
tighten the lock nut.
Low Voltage.
Motor will not start.
Motor fails to start / runs sluggish.
Fuse / Circuit Breaker repeatedly
trips.
Sanding Cuts and Sandpaper
Initial Cut
The purpose of the initial cut is to remove old finish and gross imperfections on the floor surface. Use a course (20-
36 grit) grain abrasive.
Final Cuts
The purpose of a finishing cut is to remove the scratches produced during the initial cut. Use a fine (60-80 grit) grain
abrasive.
If the surface remains rough after a finishing cut, it may be necessary to use an even finer grain of abrasive (80-
100grit). Care should be taken in selecting the grit size of the abrasive. A very fine grain will close the pores on a
wood floor making admission of a stain difficult.
Note:
If glazing or burning should occur the abrasive has dulled and must be replaced.
English - EN
Section - A
Taylor Rental Center
1560 Hwy 1 S/MLK Blvd.
Greenville, MS 38701
662-335-3535 Phone
662-335-3533 Fax
www.taylorrentalgreenville.com
Содержание American SANDERS EZ Sand - HDTR
Страница 1: ...Orbital Sander EZ Sand Operator s Manual...
