Amana IC6, Инструкции по эксплуатации и монтажу, Страница: 10 / 16

10
INSTALL THE ICE MAKER
4. HANG THE ICEMAKER ON FREEZER WALL
a. Slip the stainless steel clip over the wall of
the water cup.
Stainless steel clip
b1.Top mount only: Cover the tip of a knife
blade with masking tape to protect the inside
of the freezer. Carefully pry out and discard
the white plastic buttons from the left side of
the freezer.
b2.Bottom mount only: Unscrew remaining
phillips head screws from left side of
freezer.
c. Screw two 5 /
8
" icemaker mounting screws in
the top holes. Leave the head out
approximately
3 /
8
" for the slot in the icemaker
hanger to slip over the screws.
d. Hold the icemaker in position inside the
freezer. Insert the wire harness plug into the
connector. Verify plug orientation from
freezer connector. Plug fits only one
way. Using a rocking motion, until the
locking fingers on the sides of the plug snap
into place.
Place screws in
top screw holes
Hangers
Water fill tube
Wire
harness
connection
Water
cup
e. Slip the icemaker hanger over the mounting
screws while easing the icemaker water cup
toward the end of the water fill tube.
5. LIFT THE ICEMAKER FEELER ARM
TO THE STOP (UP) POSITION.
The icemaker should feel secure when
you lift the arm. Leave the feeler arm in
the STOP (up) position until the
refrigerator is connected to the water
supply to prevent it from operating before
the water supply connection is complete.
Arm up—
stops operation
Arm down—
icemaker will operate
Feeler arm
6. REPLACE BASKETS AND SHELVES
AND PLACE ICE STORAGE BIN ON
FREEZER SHELF.
•
Replace freezer basket(s) and
shelve(s).
•
Move the ice storage bin into place
directly under the icemaker. Adjust
shelves if necessary.
•
NOTE: Check again to make sure the
icemaker power cord is fully inserted
into its outlet.
•
Check again to make sure the
icemaker feeler arm is in the STOP
(up) position.
Feeler arm in
STOP (up)
position
The icemaker installation is now complete. Refer to the
following instructions for connecting the icemaker to the
home water supply.
The water fill tube fits under the stainelss
steel clip on the water cup. The water fill
tube must not be kinked. It should extend
approximately ½" into the water cup and
must not become easily dislodged.
f. Screw in the remaining icemaker mounting
screw. Tighten all three screws.