5
8. Remove trim on sides of doors by placing taped
edge of putty knife underneath trim and pulling out.
Caution
To avoid personal injury or property
damage, temporarily tape doors shut.
9. Tape doors shut using masking tape.
10. Remove top hinge covers by removing screws.
Trace around top hinges with a pencil. This helps
alignment when reassembling. On dispenser
models, unplug top hinge wire connectors. Remove
top hinge screws.
WARNING
To avoid electrical shock which can cause
severe personal injury or death, green ground
wire must remain attached to hinge.
11. Remove tape from refrigerator door. Grasp
refrigerator door securely and lift up while opening.
This will free door from bottom hinge pin. Top hinge
may come off door.
12. Remove toe grille by pulling forward.
Caution
To avoid property damage, drain water from
water tube into small bucket.
13. Dispenser Models
Loosen water tube clamp screw. Loosen plastic
water tube union nut. Gently pull water tube away
from union nut and through tube clamp.
14. Remove tape from freezer door. Grasp freezer door
securely and lift up while opening. This will free
door from bottom hinge pin. On dispenser models,
plastic water tube must slide through slot in bottom
door hinge as door is raised. Top hinge will remain
attached to door.
15. Remove bottom door trim by removing screws.
When installing HTK200S, HTGK200W, HTK220S
and HTK220W kits, remove door stops. Confirm
support plate is under door trim. Install new bottom
door trim by placing trim on bottom of doors. Insert
and tighten screws. When installing HTK200S,
HTGK200W, HTK220S and HTK220W kits, install
new door stops by placing door stops on bottom of
doors. Insert and tighten screws.
