Amana Front Loading Washers, Инструкция по установке и эксплуатации

Страница: 9 / 24

9
Remove both front shock sleeves and both rear
shock sleeves by pulling on the yellow rope.
A
B
A. Shock sleeve
B. Pull on cord to remove 4 shock sleeves
Shock sleeve removal
NOTE: 5 Bolts, shipping brace, 5 washers and shock
sleeves should be saved and must be
reinstalled whenever the washer is moved
more than four feet. Do not lift or transport
washer from front or sides or without shipping
materials installed.
Store shipping materials in Accessories Bag. Save
materials for use whenever the washer is moved.
Refer to
Shipping Brace Removal and Installation
section for instructions on installation.
5. Position and Level Washer
Position washer on a clean, firm, and level floor.
Remove rubber feet from accessories bag. Place
rubber feet on all four leveling legs.
Installing washer on any type of carpeting or soft
vinyl flooring is not recommended. These surfaces
contribute to vibration and a tendency for the washer
to move during the spin cycle.
NOTE: Do not slide washer across floor if leveling legs
have been extended or rubber feet have been
installed, legs and base could become damaged.
NOTE: Use of the dispenser drawer, door or control
panel as a handle in moving of washer may
cause damage to these parts.
Installing Washer
Loosen inside locknuts using a 9 /
16
" deep socket.
Adjust level legs with a 1 /
4
" socket on top of leg.
Adjust legs until machine is level front to back, side
to side and does not rock. Tighten locknuts using the
9 /
16
" deep socket. If locknuts are not tight, washer will
move out of position during operation.
• On front legs an open or box end wrench can be
used in place of deep socket. Hold leg still with 1 /
4
"
socket on top of leg. use 9 /
16
" wrench to tighten
locknut.
NOTE: Level must rest on raised portion of top panel.
See illustration.
A
B
C
D
E
F
A. Level, washer should be level front to back and side to side
B.
1
/
4
" hex, top of leveling leg
C. Locknut
D. Leveling leg
E. Rubber foot
F. Washer base
Leveling washer
Reinstall front access panel.
6. Electrical Connection
Refer to section on Electrical Requirements, and plug
in washer.
Plug in washer