Disassembly Procedures
WARNING
!
To avoid the risk of electrical shock, personal injury, or
death, disconnect power to oven and discharge capacitors
before following any disassembly procedure.
27
RS5320010 Rev. 0
1. Remove outer case wrapper with caution not to damage
components on circuit board.
2. Remove the 4 bolts securing hinges to oven cavity.
3. Remove door from oven.
4. Position new door on oven.
5. Loosely install 4 door hinge bolts.
6. With .060” (1.52 mm) shim on hinge side and .030”
(.76 mm) shim on latch side, (taped as shown)
close the door and apply light pressure on the
hinge side of the door toward the oven cavity and
tighten 4 door hinge bolts.
7. Remove shim on hinge side of door only.
8. Open and close door, observing switch
activation. Door is properly adjusted when
primary and secondary switch plungers
are fully depressed with the door closed.
9. If switch requires adjustment:
•
Open oven door
•
Loosen switch mounting screws
•
Position interlock switch assembly all
the way towards the front of the oven
•
Tighten interlock switch mounting screws
•
Close door and verify all switches are activated
10. Remove shim from latch side of inner door.
11. Re-check switch activation.
12. Reinstall outer case wrapper with caution
not to damage components on circuit
board.
13. Perform RF leakage test.
Hinge
Bolts
Component
Board
Shims
Mounting
Screws
Switch
Plungers
Door / Interlock Switch Adjustment /
Replacement
Содержание CRC510T2
