10
Features
12-hour automatic cancel
This safety feature prevents oven from continuing to operate if it has been
left on for over 12 hours. If a cooking function continues longer than 12 hours
without any options on oven control being touched, this feature turns oven
off. Any time an option is touched, 12-hour automatic cancel is reset.
Oven temperature control adjustment
Your range is calibrated at the factory for proper temperature. Due to
individual variances and preferences, it may be necessary to adjust oven
once it has been installed.
When first using the oven, follow recipe times and temperatures. Before
adjusting oven baking temperature, test a recipe, such as ready-to-bake
biscuits, by setting oven temperature higher or lower than the suggested
temperature. The baking results should help you to decide how much of a
temperature adjustment is required.
An accurate digital thermometer is necessary to calibrate the oven. Store
purchased oven thermometers do not accurately measure oven temperature.
Oven temperature can be increased or decreased by 35 °F. To avoid over
adjusting the oven, only adjust the temperature by 5 °F each time.
NOTE
: Aluminum foil alters oven performance! Do not use aluminum foil and
remove aluminum foil from racks and oven bottom if present. Check
for blocked heat vents. If it still appears oven is not performing as
expected, a calibration may be done.
1. Turn oven temperature knob to OFF.
2. Press and hold both arrow pads for approximately 5 seconds.
3. A double digit will display ranging from -35 °F to 35 °F.
4. Immediately, press either:
to increase oven temperature by 5 °F
to decrease oven temperature by 5 °F
When temperature is adjusted to a cooler setting, a minus sign (-) will
display with the offset temperature.
5. When desired temperature change is displayed, release control and
change will be automatically saved after a few seconds. Control will
return to time of day display.
Offset temperature change will be retained through a power failure.
Service codes and tones
Electronic oven control is equipped with a self-diagnostic system.
Self-diagnostic system alerts you if there is an error or problem with the unit.
If electronic range control sounds a series of short, rapid beeps for over
16 seconds and the display shows an F-code, record F-code shown.
Some F-codes can be cleared by disconnecting power to the range for
approximately 3 minutes. If the code continues to reoccur disconnect
electrical supply to range and contact an authorized servicer.
F
-
code Possible
Meaning
F1 Control
failure
F2
High oven temperature
F3
Sensor open or shorted
F9
Door latch circuit failure
DOOR
Door has not latched.