Amana AKS3020, Руководство пользователя

Страница: 12 / 28

12
Adjusting Surface Burner Flame
Properly adjusted surface burner flames are clean and
blue with a distinct inner cone approximately
1
/
4
inch to
1
/
2
inch long. See "Operating Burners"
section for burner
operating instructions.
• If burner flame is blowing or noisy, reduce airflow to
burner by adjusting air shutter.
• If burner flame is yellow and does not hold its shape,
increase airflow to burner by adjusting air shutter.
A
Burner
A—
1
/4" to
1
/
2
" inner cone length
Surface Burner Flame
Adjusting Air Shutter
1. Remove control knobs, grates, caps, and burner
bowls.
2. Remove burners by removing burner screw with
phillips screwdriver. Unplug burners from burner
wires.
3. Lift top up off burner box to expose air shutters.
4. Slide air shutter open or closed depending on
appearance of burner flame.
• If flame is yellow and does not hold its shape,
open air shutter.
• If flame is blowing or noisy, close air shutter.
A
B
C
1/8" nominal
A—Orifice Hood
B—Air Shutter
C—Venturi Tube
Air Shutter
5. Reassemble.
6. After adjustment retest burner flame.
Adjusting Surface Burner Low Flame Size
1. Push and turn burner control knob to “LITE” position.
• Burner sparks until turned from “LITE”.
2. Set burner control knob to low setting.
3. Remove burner control knob.
4. While holding valve stem stationary, turn screw in
center of burner control stem until flame is adjusted.
• Use small blade screwdriver.
Adjusting Surface Burner Low Flame Size
5. Replace burner control knob.
6. Turn surface burner control on and off to test burner
flame.
7. If flame is adjusted too low, flame may be easily
extinguished. Flame may be extinguished by drafts,
door opening or closing, heating and cooling vents,
ceiling fans, etc.
Operating Surface Burner during a Power
Failure
Although the system that lights the burners is electric,
surface burners can be ignited during a power failure.
Never attempt to light bake or broil burners during power
failure.
1.
Hold ignited match at base of desired burner.
2. Push in burner control knob and turn to
LITE position.
3. After gas ignites, remove match from burner and turn
burner control knob to desired setting.
Cleaning Cooktop, Burners, and Grates
Clean cooktop, caps, and grates using damp cloth and
soapy water. If necessary, clean with nonabrasive
cleaners or pads. Dry thoroughly when finished to avoid
rusting.
• Do not use harsh powders, oven cleaners, scouring
pads, or steel wool.