9
Complete Connection
1.
Locate gas pressure regulator in the back of the range.
A. Gas pressure regulator
IMPORTANT:
Do not remove the gas pressure regulator.
2.
Check that the gas pressure regulator shut-off valve is in the
“ON” position.
A. “ON” position
B. “OFF” position
IMPORTANT:
The factory default setting is the “ON” position.
If the range does not work, verify that the valve is in the “ON”
position.
3.
Open the manual shutoff valve in the gas supply line. The
valve is open when the handle is parallel to the gas pipe.
A. Closed valve
B. Open valve
4.
Test all connections by brushing on an approved
noncorrosive leak-detection solution. Bubbles will show
a leak. Correct any leak found.
5.
Remove cooktop burner caps and grates from parts
package. Align notches in burner caps with pins in burner
base. Burner caps should be level when properly positioned.
If burner caps are not properly positioned, surface burners
will not light. Place burners, burner caps, and grates on the
cooktop.
6.
Plug into a grounded 3 prong outlet.
Verify Anti-Tip Bracket Is Installed
and Engaged
1.
Place the outside of your foot against the bottom front of the
broiler and grasp the lower right or left side of the control
panel as shown.
NOTE:
If your countertop is mounted with a backsplash, it
may be necessary to grasp the range higher than is shown in
the illustration.
2.
Slowly attempt to tilt the range forward.
If you encounter immediate resistance, the range foot is
engaged in the anti-tip bracket.
3.
If the rear of the range lifts more than 1/2" (1.3 cm) off the
floor without resistance, stop tilting the range and lower it
gently back to the floor. The range foot is not engaged in the
anti-tip bracket.
IMPORTANT:
If there is a snapping or popping sound when
lifting the range, the range may not be fully engaged in the
bracket. Check to see if there are obstructions keeping the range
from sliding to the wall or keeping the range foot from sliding
into the bracket. Verify that the bracket is held securely in place
by the mounting screws.
4.
Slide the range forward and verify that the anti-tip bracket is
securely attached to the floor or wall.
5.
Slide range back so the rear range foot is inserted into the
slot of the anti-tip bracket.
A
B
A
A
B
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING