-7-
RANGE ADJUSTMENTS
Top Section - Electric Ignition
To operate, push and turn top burner knob to the LITE
position. The top burner will light. To turn OFF spark after
the top burner has ignited, turn knob to HI setting.
NOTE:
Top burners are not adjustable.
Air Shutter - Bake/Broil Burner
NOTE:
If oven burner does not ignite, check oven gas
shut-off position at the regulator.
a.
The approximate length of the flame of oven burner is
a 1/2 inch distinct inner blue flame, figure 4.
FIGURE 4
b.
Bake/broil burner flame can be checked as follows:
1.
Yellow flame on burner - open burner air shutter
to the widest opening that will not cause the flame
to lift or blow off the burner when cold. (See #2 on
figure 5). Some yellow tipping on LP is normal.
2.
Distinct blue flame but lifting - close burner air
shutter to the point where it will not cause the
flame to lift or blow off the burner when cold. (See
#2 on figure 5).
FIGURE 5
GAS CONVERSION
When conversion is required, convert regulator before
installation.
To access the regulator shut-off from front of range,
remove the storage drawer.
To remove storage drawer: Pull out to the first stop
position. Lift up front of drawer and pull to the second
position, grasp sides and lift up and out to remove drawer.
To replace: Fit the drawer rollers onto the rails. Lift up
drawer front and gently push in to first stop position. Lift
up and continue to slide drawer to the closed position.
General
This unit is equipped with a convertible appliamce
pressure regulator, fixed bake & broil orifice hoods, and
top burner orifices pre-set at the factory for natural gas.
To convert the unit to either LP or Natural gas will require
adjustment of the air shutter on the bake & broil burner,
adjustment of the pressure regulator converter cap, and
replacement of the bake and broil burner orifice hoods
and top burner orifices.
NOTE: Bake and broil burner orifice hoods and top
burner orifices for converting unit to LP gas
are contained in a kit attached to rear of unit.
Conversion instructions are included in kit.
Save orifices removed from appliance for
future use.
Inlet pressure to the appliance pressure regulator should
be as follows for both operation and checking of appliance
pressure regulator setting:
INLET PRESSURE IN
NATURAL
LP
INCHES OF WATER COLUMN
GAS
GAS
Minimum
5
11
Maximum
14
14