6
5. Replace the battery holder in the plastic battery box with the
battery facing the bottom and the blue wires facing up, and
close the plastic battery box.
6. Reinstall the metal battery top and secure it with the screw.
IMPORTANT: Do not operate bake burner without the metal
battery top installed and secured.
7. Replace the broiler pan and grill in the broiler rack.
8. Close the broiler door.
Test the battery by lighting a burner. See “Electronic Ignition
System” section in the Installation Instructions. The electrode in
each burner will spark and make a clicking noise.
When the battery needs to be replaced, follow these instructions
and remove the old battery before inserting a new battery.
Properly dispose of the old battery. See the “Battery Status
Indicator” section to know when to replace the battery.
Battery Status Indicator
■
The battery status indicator on the control panel will show the
recommended time to replace the battery.
■
If the battery status indicator lights up red when any of the
burner knobs is in the LITE position, then it is recommended
you replace the battery with a new alkaline 9V DC battery.
NOTE: If any knob is turned to the LITE position and there is no
clicking noise or the battery status does not light, either the
battery power is very low or completely discharged, or there is no
battery connected to the battery case. In this event, replace the
battery or install a new alkaline 9V DC battery.
IMPORTANT: If the range will be unused for a long time, it is
recommended that the battery is removed and stored out of
reach of children. Reinstall the battery when the range will be
used again.
NOTE: Remove the battery before moving the range. Reinstall
the battery after the range has been reconnected.
Battery status indicator
While a knob is in the LITE
position, if:
Then:
Battery status light is OFF and
igniters spark
The range is operating
normally
Battery status light is ON and
igniters spark
Change battery soon
Battery status light is ON and
igniters do not spark
Change battery now
Battery status light is OFF and
igniters do not spark
Change battery now or check
to ensure battery is installed
correctly