Amana AER5725QAW, Инструкция по использованию и уходу, Страница: 6 / 20

5
Notes:
• If the oven door is left open, “door” will flash in the
display and a signal will beep until the door is closed
and the Clean pad is pressed again.
• If more than five seconds elapse between pressing the
Clean pad and the
▲
or
▼
pad, the program will
automatically return to the previous display.
• The oven door will be damaged if the oven door is
forced to open when LOCK is still displayed.
During the Self-Clean Cycle
When LOCK shows in the display, the door cannot be opened.
To prevent damage to the door,
do not force the door open
when LOCK is displayed.
Smoke and Smells
You may see some smoke and smell an odor the first few
times the oven is cleaned. This is normal and will lessen in
time.
Smoke may also occur if the oven is heavily soiled or if a pan
was left in the oven.
Sounds
As the oven heats, you may hear sounds of metal parts
expanding and contracting. This is normal and will not
damage the oven.
After Self-Cleaning
About one hour after the end of the self-clean cycle, LOCK
will turn off. The door can then be opened.
Some soil may leave a light gray, powdery ash. Remove
it with a damp cloth. If soil remains after wiping, that means
the clean cycle was not long enough. The soil will be
removed during the next clean cycle.
If oven racks were left in the oven and do not slide
smoothly after a clean cycle
, wipe racks and rack supports
with a small amount of vegetable oil to make them easier to
move.
CAUTION
Cleaning Procedures
• Be sure appliance is off and all parts are cool before
handling or cleaning. This is to avoid damage and
possible burns.
• To prevent staining or discoloration, clean appliance after
each use.
• If a part is removed, be sure it is correctly replaced.
Backguard and Cooktop –Porcelain Enamel
Porcelain enamel is glass fused on metal and may crack or
chip with misuse. It is acid resistant, not acid proof. All
spillovers, especially acidic or sugary spillovers, should be
wiped up immediately with a dry cloth.
• When cool, wash with soapy water, rinse and dry.
•
Never wipe off a warm or hot surface with a damp cloth.
This may cause cracking or chipping.
• Never use oven cleaners, abrasive or caustic cleaning
agents on exterior finish of range.
Clock and Control Pad Area
• To activate control lock for cleaning, see “Locking the
Controls” page 12.
• Wipe with a damp cloth and dry. Do not use abrasive
cleaning agents as they may scratch the surface.
• Glass cleaners may be used if sprayed on a cloth first.
DO NOT spray directly on control pad and display
area.
Control Knobs
• Remove knobs in the OFF position by pulling forward.
• Wash, rinse and dry.
Do not use abrasive cleaning agents
as they may scratch the finish.
• Turn on each element to be sure the knobs have been
correctly replaced.
If the oven has already been set for a clean
cycle and you wish to set a delay:
1. Press the Delay pad.
• DELAY flashes.
• 00:00 will appear in the display.
2. Press the
▲
or
▼
pad to set the amount of
time you want to delay the cycle.
After four seconds, CLEAN, DELAY and
LOCK will appear in the display to show
that the oven is set for a delayed clean
operation. The delay time is displayed.
When the Self-Clean cycle starts:
• DELAY will turn off.
• The clean time will appear in the display.
To cancel the Self-Clean cycle:
Press the Cancel pad.
• All words disappear from the display.
• All functions are canceled.
• The time of day appears in the display.
6. After four seconds, CLEAN, DELAY and LOCK will appear
in the display to show that the oven is set for a delayed
clean operation. The delay time is displayed.
Fine lines may appear in the porcelain because it went
through heating and cooling
. This is normal and will not
affect performance.
A white discoloration may appear after cleaning if acidic
or sugary foods were not wiped up before the self-clean
cycle
. This discoloration is normal and will not affect
performance.