10
Step 3 Adjust the Tilt Angles of TV
1. Loosen the two tilt tension nuts [T] on both brackets using wrench (not included).
2. Adjust the hooks of the brackets to the desired angles.
3. Tighten tilt tension nuts with a wrench (not included) to fix the tilting angle
of the TV.
Note: The tilt angles of the hooks on the TV brackets must be the same.
3/8 in. (10mm)
Wrench
(Not Included)
2B-3
C
01
B
A
Use the hammer to knock
anchors [C] into the wall. Be
sure the anchors [C] are
seated flush with the
concrete surface.
Install wall plate [01] using lag screws [A]
and washers [B]. DO NOT over-tighten
the lag screws [A]. Tighten the lag
screws [A] only until the washers [B] are
pulled firmly against the
wall plate [01].
T
Note: Do not over-loosen or
over-tighten the nuts on the
brackets
T
Tighten
Loosen
1/2 in. (13mm)
Socket Wrench
(Not Included)
