Always
O
n UPS Systems
M1201_Din_Rail_AC-DC_600VA_Manual V1.6 2012-06-12.doc
4
Input and Output Terminal Block Connections
Side Mount Input and Output Terminal Blocks
INSTALLATION
Unpacking and Inspection
Examine the packaging for damage. Inform the carrier immediately if and/or when damage is
noticed. Retain the packaging for future use.
Placement
Install the UPS in a protected area with adequate air flow and free of excessive dust. Do not operate the
UPS where the temperature and humidity is outside the specified limits.
Connect to Utility
Connect the AC input power connector (Included) to utility power.
Charging the Battery
The UPS charges its battery whenever the UPS is in LINE mode. For best results, charge the battery
for 4 hours initially before connecting the load.
Connecting the Loads
Plug the loads into the output connectors on the rear of the UPS. To use the UPS as a master on/off
switch, make sure all of the loads plugged into the UPS are switched on.
L N G
AC INPUT
L N G
AC OUTPUT
+ -
DC OUT
