STEP 5: Gimbal Balancing – Roll Axis
Loosen these 2 Screws.
(Hold the Camera at
the same time)
Adjust the Roll Assembly to Left/ Right as to
balance the CG.
Set it to be Parallel before tighten the Screws.
Tighten these 2 Screws.
Test if the Roll Axis is balanced well. The Roll
Assembly(with Camera) should always remain
steady in any Angle if it has correct CG.
Test on about 45 degree. Camera should
remain steady if the CG is correct. Repeat the
previous steps to get the correct CG.
(Be
Patient Here)
12
