Alvarion BreezeACCESS EZ AU-EZ, Системное руководство

Страница: 62 / 175

Chapter 4 - Operation and Administration Menus and Parameters
BreezeACCESS EZ AU-EZ 43 System Manual

Set Partial Factory Defaults

Set Complete Operator Defaults

Set Partial Operator Defaults

Cancel Current Pending Request
4.2.3.2.1.1 Set Complete Factory Defaults
Select this option to reset the unit to the standard Factory Defaults configuration,
excluding several parameters that are listed in
Table 4-2 .
4.2.3.2.1.2 Set Partial Factory Defaults
Select this option to reset the unit to the standard Factory Default configuration,
excluding the parameters that are required to maintain connectivity and
management access. The parameters that do not change after Set Partial Factory
Defaults are listed in
Table 4-3 .
Table 4-2: Parameters that are not changed after Set Complete Factory/Operator
Defaults
Parameters Group Parameter
Unit Control Parameters All Passwords
FTP Server IP address* (see note below)
FTP Gateway IP address* (see note below)
FTP User Name* (see note below)
FTP Password* (see note below)
Ethernet Port Negotiation Mode
Air Interface Parameters Frequency
DFS Required by Regulations
Frequency Subset
Antenna Gain
Country Code Parameters Selected Country Code
NOTE
The FTP parameters are not set to their default values after Set Complete Operator Defaults.
However, they are set to their default value after Set Complete Factory Defaults. Note that in this
case they are set to the default values immediately upon selecting the Set Complete Factory
Default option (even before the next reset).