Alvarion 43222600, Системное руководство

Страница: 86 / 129

WBSn-2400 and WBSn-2450 System Manual
Chapter 3 - Base Station ManagementNetwork
Chapter 3 - Base Station Management Network
76
„
Scan results table, sorted by Score value (see below) providing the following details for each channel:
»
Channel ID : The channel number.
»
Channel Frequency [KHz]
»
Score : An indicator of the channel’s quality based on the measurements of Noise Level, Activity
and Interference (see below).
»
Noise Level [dBm] : The measured noise level in dBm.
»
Activity [%] : Percentage of time that there has been activity in the channel during the
measurement period.
»
Interference [%] : Percentage of time that there has been interference (non-valid traffic) in the
channel during the measurement period.
Click on the Scan button to run the interference analyzer for the radio band.
Click on the Scan and Switch button to run the interference analyzer and automatically switch to the
best channel after completion of the task.
3.5.2.1.1.5 Per Wireless Network Buttons
The following buttons are available for each configured wireless network:
„
Disable/Enable : Click to disable/enable the wireless network.
„
Edit : Click to open the configuration page for the specific wireless network.
„
Remove : Click to remove the specific wireless network.
By default, there is one wireless network for each radio. This wireless network cannot be removed.
3.5.2.1.2 Wireless Adapter 802.1an
The Wireless Adapter 802.11an section (not applicable for WBSn-2400 units) provides for the 5 GHz
radio the same information and general management functionality as the provided for the 2 GHz radio
in “Wireless Adapter 802.1bgn” on page 72 .
3.5.2.1.3 Associated Stations
This section shows the following details for each of the end-user devices connected to the AP.
NOTE!
During channel scan process normal operation of the device is interrupted.