WBSn-2400 and WBSn-2450 System Manual
Chapter 3 - Base Station ManagementNetwork
Chapter 3 - Base Station Management
Network
64
By default, the device is supplied in Bridge mode with all physical interfaces assigned to the LAN zone.
The LAN interface is configured as the management interface (see Management Interface in
below). The default Protocol is DHCP client. In this mode no physical
interface is assigned to the WAN interface.
3.5.1.2.2
Switching from Bridge Mode to Router Mode and Vice Versa
To avoid possible lose of management connectivity, follow these steps:
1
In the WAN page:
a
In the Common Configuration section select the General Setup tab. In the Management Interface
parameter drop-down list select the Management option to enable remote management via the
Ethernet backbone.
b
Make sure that the Fallback IP parameters (see
) are configured properly
(applicable for the default DHCP client option for the Protocol parameter).
c
In the Physical Settings tab select the Ethernet Adapter: “eth0” option to assign the Ethernet
interface to the WAN.
d
Click on the
Save
button to apply the change.
2
In the LAN page:
a
Set the Protocol to Static address (you will be requested to confirm the action by clicking on the
Switch protocol
button that will become available) and configure relevant parameters. Make
sure that different subnets are configured for the LAN and WAN zones.
b
In the DHCP Server section, enable the DHCP server and configure relevant parameters (see
). You may configure also Static Leases (see
3
Click on the
Save & Apply
button to apply the changes.
To avoid possible lose of management connectivity, follow these steps:
CAUTION
Do not execute the
Switch protocol
action in the AVLAN3316 page.
To switch from Bridge mode to Router mode:
To switch from Router mode to Bridge mode:
Содержание 43222600
Страница 1: ...System Manual WBSn 2400 and WBSn 2450 Software Version 2 0 June 2015 P N 216066...
Страница 11: ...Chapter 1 Introduction In This Chapter WBSn System Description on page 2 Specifications on page 3...
Страница 127: ...Appendix B Preparing Ethernet Cables In this Appendix Preparing the Base Station s Ethernet Cable on page 116...