Reset the expansion card
by pressing the
factory default switch until the expansion card’s
LEDs flash once (roughly 5 seconds). This is
normally never required.
Cellular LED Indicators
are used to show
the state of the expansion card. The CS and
Platform LEDs are not used.
LED
Indication
Power
(Green)
ON and Flashing off once
every second
- Powered and
running
Cellular
(Red)
ON
- Registered with the local
cellular network
Note:
If the cell LED displays two quick flashes
(then repeats every second), this indicates it was
not able to connect to the network. There could
be a delay before retrying the connection.
Signal Strength
can be determined using the
signal bar LEDs.
Signal Bar Cellular Signal Strength
0
Bad (0 to 14)
1
Marginal (15 to 19)
2
Acceptable (20 to 24)
3
Good (25 to 30)
4
Best (30+)
Factory Default Switch
Signal Bar LEDs
Cellular LED Indicators
Troubleshooting Cellular Expansion Card Problems:
• Ensure antenna connectors are securely snapped into the circuit board
•
Try repositioning the panel (move or rotate)
• Try moving the panel higher in the building
•
Try moving the panel away from metal objects (appliances, ducts)
• Try moving the panel closer to a window
•
Use a remote RE036 or RE046 antenna option (see below)
