Pro Tips
3M VHB Tape
works great if the surface is properly prepared and firm pressure is applied
for over 10 seconds.
Surface Preparation
• Clean the surface
• Ensure the mounting surface temperature is above 50 °F
Reversible
mounting plate
allows for easy use on a wall or table. For table top use,
remove and reverse the mounting plate and install the rubber feet supplied.
To
replace the battery
insert a screwdriver into the latch slot on either side of the
PINPad and pop the cover off the wall plate. Replace the battery and reinstall the
cover onto the wall plate.
Specifications
Physical
Housing Dimensions
Weight with Battery
Mounting Fastener
2.28 x 1.97 x 0.40 inches (5.8 x 5.0 x 1.0 cm)
0.70 ounces (20 grams)
3M VHB™ Tape or #4/#6 screws (Mounting screws not provided)
Environmental
Operating Temperature
Maximum Humidity
32 to 120 °F (0 to 49 °C)
85% relative humidity non-condensing
Sensor Specifications
Frequency
Replacement Battery
Nominal Battery Life
Battery Voltage
Current Draw
Transmitted Indications
433.92 MHz
One Panasonic CR2032
4 to 6 years
3.0 VDC (Nominal), 2.2 VDC (Low)
20 mA (Maximum), 1 uA (Quiescent)
Low Battery, Supervision
Certification
RE652
RE652-CE
UL634, ULC634, FCC, IC
EN50131-1, EN 60950-1, EN300 220, EN301 489, CE, RCM
Specifications subject to change without notice.
WARRANTY
Alula will replace products that are defective in their first five (5)
years.
IC NOTICE
This device complies with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference
that may cause undesired operation of the device.
Le présent appareil est conforme aux cnr d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes:
(1) L’appareil ne doit pas produire de brouillage, et
(2) L’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
IC: 8310A-RE652
FCC NOTICE
This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference that may be received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by Alula could void
the user’s authority to operate this equipment.
FCC ID: U5X-RE652
CE DECLARATION OF CONFORMITY
Hereby, Alula declares that this RE652-CE is in compliance with the
essential requirements and other relevant provisions of directive
1999/5/EC.
(This declaration can be translated to other languages via a myriad
of translation tools found on the Internet.)
47-0007-08 • REV C • 2018-03-02
Tech Support Line • (888) 88-ALULA • (888) 882-5852
01