Altusen ALTUSEN CC2000, Руководство пользователя, Страница: 136 / 271

CC2000 User Manual
122
Serial Devices and Ports
Selecting a Serial device, such as the SN0108, brings up a page with the
following entries on the Panel Menu bar: Properties, Access Rights, and
Device Configuration. When you select a port on the Serial device, the
Device
Configuration heading changes to Port Configuration .
Properties
With the exception of one additional menu item, Enable SN device session
history to be sent to the CC , the settings found on the Properties page for the
device, or port are similar to the ones described in the Adding Devices section.
(See the table on page 83, for details.)
„
SN device session history
If Enable SN device session history to be sent to the CC is selected, the serial
device’s session history will be sent to, and stored on the CC2000 server, where
it will becomes part of the CC2000’s searchable database.
„
Action Buttons
These buttons perform the same functions as they do on KVM ports.
See
Properties Page Action Buttons , page 105 for details.
Access Rights
Access rights can be configured for the entire device or port-by-port. After
selecting the device, or port, clicking this Panel Menu item brings up a page
that shows a list of all the users and groups that have been given access to it.
„
Adding Users or Groups to the Device or Port Access List
To give a user or group access to the device or port, do the following:
1. Click Add . A list of qualified users and groups appears.
2. Click to put a check in the checkbox in front of the names of the users or
groups that you want to access the device or port.
3. Set the configuration rights for the users or groups:
Š
Allowed – The user or group can configure the device’s settings.
Š
Denied – The user or group cannot configure the device’s settings.
4. If a Device was selected, set the access rights for the users or groups:
These are the same as the ones described for KVM devices. See Set the
access rights for the users or groups: , page 106 for details
5. If a Port was selected, set the access rights for the users or groups:
Š
Telnet – The user or group must access the port via a Telnet session.
Š
SSH – The user or group must access the port via an SSH session.
cc2k.book Page 122 Tuesday, December 21, 2010 4:00 PM