3. Installation
29
Module Removal
The following example shows a generic Hadron Xtorm module so that the procedure here described
applies to all modules of the Series.
First, pull the retention cursor (Figure 3-9 /1) in order to unlock it from the bus and then rotate it in
one single and continuous movement (Figure 3-9 /2).
Figure 3-9. Bus Disconnection
By properly following the procedures described above, the module will be perfectly disconnected
from the bus and just remove the same as shown on Figure 3-10. Remove only one module at a time.
Upon completion of this procedure, wait at least two seconds for the implementation of a new
insertion / removal procedure.
