Altronix is not responsible for any typographical errors.
140 58th Street, Brooklyn, New York 11220 USA | phone: 718-567-8181 | fax: 718-567-9056
website: www.altronix.com | e-mail: [email protected] | Lifetime Warranty | Made in U.S.A.
IIAL100ULB - Rev. 061214 H29Q
MEMBER
Note: For Access Control applications batteries are optional.
When batteries are not used, a loss of AC will result in the loss of output voltage.
When the use of stand-by batteries is desired, they must be lead acid or gel type.
LED Diagnostics:
Green (AC)
Power Supply Status
ON
Normal operating condition.
OFF
No DC output.
Slow Blink
Loss of AC.
Rapid Blink
Unit is triggered, awaiting reset. Fire alarm interface activated.
Terminal Identification:
Terminal Legend Function/Description
XFMR
Low voltage transformer connections.
+ AUX --
Aux power output terminals. These terminals will supply 12VDC or 24VDC,
not affected by trigger, reset or fire alarm interface.
LOCK+
COM --
Switched power output. Fail-Safe [LOCK+] supplies positive power when unit is not trig-
gered and FACP interface is inactive. Fail-Secure [] supplies positive power when
unit is triggered and/or fire alarm interface is activated. [COM-- ] supplies negative power.
FACP1
FACP2
Supervised by 2.2K end of line resistor FACP interface. Short or open will cause power to
be dropped to terminal marked [LOCK+] and supply power to terminal marked [].
Condition can be maintained even after restoration of the circuit (latching mode).
TRG INPUT
NO, GND
Short between these two terminals will cause power to be dropped to terminal marked
[LOCK+] and supplied to terminal marked [].
RESET
NO, GND
Momentary short between these terminals would end latching FACP interface condition
Feature active only if latching FACP is selected (SW1 closed).
+ BAT --
Stand-by battery connections.
Application Diagram:
VR1
NO
NO
GND
GND
FACP1 FACP2
COM--
LOCK+
+ AUX --
TRIG INPUT
RESET
SW1
+ BA
T
--
XFMR
Normally Open
Access Control
Triggering
Device
Normally Open
Reset Device
2.2K EOL
(supplied)
MAG LOCK
NC
FACP
NO
FACP
{ }
Card
Reader
Transformer
Stand-by
Batteries
ON
ON
SW2:
OFF-12VDC
ON-24VDC
Fig. 1
Fig. 1a - SW2
VR1
NO
NO
GND
GND
FACP1 FACP2
COM--
LOCK+
+ AUX --
TRIG INPUT
RESET
SW1
+ BA
T
--
XFMR
Normally Open
Access Control
Triggering
Device
Normally Open
Reset Device
2.2K EOL
(supplied)
MAG LOCK
NC
FACP
NO
FACP
{ }
Card
Reader
Transformer
Stand-by
Batteries
ON
ON
SW2:
OFF-12VDC
ON-24VDC
