1411 S. Roselle Rd. Schaumburg, IL 60193 Phone (847) 923-0002 Fax (847) 923-0004
WiringSystem:
IGN Ctrl
–
Connect ignition signal or other switched signal to IGN Ctrl terminal. This input will allow (
Trig enabled (IGN)
) channels to turn on/off
when ignition is turned on/off. Also, ignition can control system power up and down if
Ignition/Switch Power
off is enabled in
SETUP
menus (see
Configure section)
Trig1 Trig 2
–
This input will allow (
Trig enabled
) channels to turn on/off when Trig 1 or Trig2 signal is turned on/off. Feature must be enabled in
SETUP
menus (see Configure section)
Terminals 2 and 3: Connect
to
Temperature
sensor
(included).
Ground
Terminal: Use #12
AWG Wire. (Recommend
to Battery Negative Post or
Good Chassis Ground
Point)
Connect this wire
first!
B
: Use minimum
4 AWG cable. Connect to
Positive Post on Battery
IMPORTANT: Install
independent cable direct
to battery or battery
disconnect switch
(kill switch).
Do not splice from another
power cable or junction.
Max torque on nuts:
24
inch
-lb
(2 ft-lb)!!!
For Circuits (Starter, Ignition, Fuel,
etc..) use appropriate 14awg (30
amp), 16awg (20 amp), or 18awg (15
amp) wire depending on load.
Connect Cable from Touch Screen
