Altocraft 18 GA.BRAD, Руководство оператора

Страница: 6 / 9

CAUTION: Disconnect the tool from air supply before performing any service
procedure. When inserting new or re-installing O-rings, make sure they are clean
and lubricated with an O-ring lubricant.
WARNING: Repairs should be made by an authorized repair centre.
Opening this tool could invalidate your warranty.
!
!
!
PROBLEM CAUSE SOLUTION
Air leak at trigger area O-ring in trigger valve
damaged or cracked
Check and replace O-ring
Trigger valve head damaged Check and replace trigger valve head
Trigger valve stem, seal, or
O-ring damaged
Check and replace trigger valve stem
Air leak between body and
front plate
Piston O-ring or bumper
damaged
Check and replace O-ring or bumper
Air leak between body and
cylinder cap
Screw loose Tighten screws
Damaged seal Check and replace seal
Tool driving fasteners too
deeply
Worn bumper Replace bumper
Air pressure too high Adjust air pressure at regulator
Tool runs slowly or has power
loss
Insufficient lubrication Add oil as instructed
Insufficient air supply Check air supply
Broken spring in cylinder cap Replace spring
Exhaust port in cylinder head
is blocked
Replace damaged internal parts
Tool skips fasteners Worn bumper or damaged
spring
Replace bumper or pusher spring
Dirt in front plate Clean drive channel in front plate
Inadequate airflow to tool Check hose and compressor fittings
Worn or dry O-ring on piston Replace or lubricate O-ring
Damaged O-ring on trigger
valve
Replace O-ring
Cylinder cap is leaking Replace seal
Fasteners jam in tool or in
magazine
Joint guide is worn Replace joint guide
Fasteners in tool are the
wrong size or damaged
Use only recommended fasteners
Magazine screws or front
plate clamp are loose
Tighten all
Blade in piston assembly is
damaged
Replace piston assembly
Tool will not drive fasteners
down tight
Worn blade in piston
assembly
Replace piston assembly
Lack of power Adjust regulator to adequate pressure
Slow cycling and loss of
power
Check cylinder cap spring for broken coils, reduced
length, or if exhaust port is blocked
STOP using the tool immediately if any of the following problems occur. Serious
personal injury could occur. Any repairs or replacements must be done by a
qualified person or an authorized service centre onl y.
TROUBLESHOOTING
6