29
During operation
Do not damage mains
connecting cable (e.g. by driving
over the cable, pulling the cable,
crushing the cable).
Always disconnect mains cable
at plug (not by pulling out using
the connecting cable).
When the machine is not being
operated, switch brush unit off
immediately in order to avoid
damage to floor surfaces.
If either fluid or foam escapes
from the machine
unintentionally, switch automatic
cleaning machine off
immediately.
Check filling level at regular
intervals and empty dirty water
tank in good time.
Use brushes, pads and
accessories as described in the
operating instructions. Failure to
comply with this can be
hazardous.
When leaving the machine
unattended, disconnect mains/
battery plug and safeguard
machine from unauthorised use.
Maintenance and repair
WARNING!
Always disconnect the mains/
battery plug before cleaning
and maintaining the
automatic cleaning machine.
Only carry out the maintenance
work described in the operating
instructions. Always use original
spare parts.
WARNING!
Do not make technical
alterations to the automatic
cleaning machine.
This can put your safety at risk.
Please contact the Alto
customer service department or
an authorised specialist
workshop for other maintenance
and repair work!
2 Description
2.1
Use for intended
purpose
The automatic cleaning
machine is exclusively intended
for wet cleaning of water-
resistant floor coverings in
building interiors.
The automatic cleaning
machine must not be used on
public rights of way and roads.
Any other use is considered to
be improper. The manufacturer
is not liable for any resulting
damage; all risks are the
responsibility of the user.
Use for intended purpose also
includes adherence to the
manufacturer’s operating,
service and maintenance
conditions.
Modifications made to the
automatic cleaning machine by
the user releases the
manufacturer from all liability for
resulting damage.
Floor coverings must be
checked for suitability for this
cleaning method before using
the automatic cleaning
machine!
Please pay attention to surface
pressure in case of point-elastic
floors such as in gymnasiums!
The manufacturer does not
accept liability for damage
caused to the machine and the
floor covering being cleaned if
the wrong brushes and cleaning
agents have been used.
