10
2. Set Up the Transmitter
Condenser Vocal Microphone Transmitter:
1.
Remove the transmitter’s
battery compartment
cover and insert
2 AA
batteries into the
compartment. Make sure the polarities of the batteries (
+
and
–
) are correct.
2.
Reattach
battery compartment
cover to the transmitter.
3.
Press the transmitter’s
Power Button
for
4
seconds to power the transmitter on or off.
Wireless Belt-Pack Transmitter:
1.
Remove the transmitter’s
battery compartment
door and insert
2 AA
batteries into the
compartment. Make sure the polarities of the batteries (
+
and
–
) are correct.
2.
Press the transmitter’s
Power Button
for
2
seconds to power the transmitter on or off.
3. Synchronize the Receiver and Transmitter
1.
Make sure the receiver and transmitter are within
3
feet (
1
meter) from each other and
powered on.
2.
Press and hold the
Sync
button on the transmitter until
Sync
flashes in the receiver’s
display
.
3.
Press the
Sync
button on the receiver.
4. Adjust Your Levels and Settings
Gain Level:
If you are using a wireless belt-pack transmitter, set its
Gain Selector
to
10 dB
,
0 dB
, or
-10 dB
to set the gain of the audio input.
Volume Level:
Use the receiver’s
Volume Knob
to set the audio signal level sent from the
receiver’s
audio output
to your mixer or amplifier system.
Squelch Level:
Use the
Squelch Knob
to adjust the noise floor level, minimizing background
or ambient noise during silent moments. Higher settings allow for greater noise reduction and
dynamic range, but a setting that’s too high can cause intentionally quieter sounds to be
silenced along with the noise. Be sure to experiment with different settings to find an optimal
balance.
