3. CONTROL ELEMENTS
SPO
TLIGHT
3
8 IEC SOCKET FOR AC POWER CABLE
Connect the supplied main cord. Do not insert the power cord into the MISTRAL
900/1500 amplifiers and into the AC Outlet until voltage has been correctly set.
9 CIRCUIT BREAKER (Manual reset button)
This is an electronic fuse for protecting the unit from possible damage. When
the unit is overloaded or the temperature inside the unit is too high, this push
type button will spring out and disconnect the power supply. Push the Breaker
down again to restore normal working conditions.
10 OUTPUT CONNECTOR
These connectors have two kinds: Binding post and Neutrik connector. You can
choose proper connectors according to practical need. For your safety, please
be careful when do connecting work.
11 LIMITER SWITCH
Set the switch at "ON" position, when the output level is above maximum, the
clip begins, thus keeping consistent output level for protecting apparatus. If
the switch is set at "OFF" position, this clip function doesn't work.
12 BALANCED INPUT CONNECTOR
These connectors connect the input signal of CH 1 and CH 2 separately.
13 BALANCED OUTPUT CONNECTOR
These two output connectors are parallelled inside with input connectors. It enables
the unit work under parallelled mode. Please also refer to wiring diagram for
parallelled mode.
7 COOLING FAN
This fan secures enough cooling for your amplifier. The fan speed is electronically
regulated depending on the temperature of the power devices.
12
9
8
10
7
14 11
SERIAL
MODEL
Apparaten skall anslutas
till jordat uttag nar den
ansluts till ett natverk
CH1
CH2
BRIDGE
MONO
BREAKER
PARALLEL
OUTPUT
PARALLEL
OUTPUT
OUTPUT2
OUTPUT1
POWER OUTPUTS
CH1
1+
1-
POS NEG
CH2
2+
2-
POS NEG
BRIDGE
1+
2+
POS NEG
CH2
1+
1-
POS NEG
TIP/PIN 2
RING/PIN 3
SLEEVE/PIN 1
TIP/PIN 2
RING/PIN 3
SLEEVE/PIN 1
MODE
BRIDGE
STEREO
INPUT
CH2
CH1
LIMITER
OFF
ON
1
2
3
2
1
3
NEW
TIDE
2
1
3
NEW
TIDE
1
2
3
13
Rear panel
Содержание MISTRAL 1500
Страница 16: ......
