5
3.2 The Rear Panel
7. AC inlet and fuse holder
Use it to connect your MAXI-Q PC to the supplied AC cord. Please check the voltage in your country and what
voltage for your MAXI-Q PC is configured before attempting to connect the unit for the main AC. The fuse can
protect the AC supplies circuit of the equipment.
If there is something wrong with the fuse or the fuse needs to replace, please refer to a qualified
CAUTION:
technician. If the fuse continues to blow after replacing, discontinue using this unit before it is repaired.
8. RS485 OUT
This is the standard serial communication interface. It allows outgoing communication between a MAXI-Q PC
and other MAXI-Q PC units. The RS485 interface is very suitable for remote control over long distances (difficult
with RS232 standard ports) and daisy-chaining several MAXI-Q PC units.
9. RS485 IN
The function of the RS485 IN interface is opposite to RS485 OUT. It allows incoming communication between
a MAXI-Q PC and other MAXI-Q PC units. The RS485 interface is very suitable for remote control over long
distances (Difficult with RS232 standard ports) and for daisy-chaining several MAXI-Q PC units.
10. OUTPUTS
These (Outputs1~2) are balanced XLR-M connectors. The high quality, low noise, 24 bit converters can make
D/A conversion.
11. INPUTS
INPUT A and INPUT B are compatible with balanced XLR and JACK. They are audio connectors of the respe-
ctive sections. The high quality, low noise, 24 bit converters can make A/D conversion.
4. GETTING STARTED
The powerful versatile signal processor MAXI-Q PC is mainly designed for use with audio systems. Its configurations
of the input and output can be set only by recalling one of the presets included in the internal memory or PC Editor
software. So the user must be very clear about the main function of the unit in order to get a best operation of your
MAXI-Q PC. Before you start your operation, please read the following parts carefully:
RS485 OUT
RS485 IN
INPUT A
INPUT B
2
1
OUTPUTS
A102
AC INPUT
14W
95-240V
50/60Hz
FUSE: 95-120V T500mAL
210-240V T315mAL
Apparaten skall anslutas till
jordat uttag nar den ansluts
till ett natverk
Use only with a 250V fuse
PUSH
PUSH
PUSH
7
8
9
10
11
4.1 Configuration of the system
At first, switch off the equipment, carry out the audio and power connection from the various components of your
sound system. Then, connect the main cord and only switch on the MAXI-Q. The display will show the data reg-
arding with the operating system release for a few seconds.
1 . 0
Note:
MAXIEDITOR software, which is used in the unit , accepts these four COM1-COM4 connectors
of PC
only. So when you use USB port for connecting, please operate it as follows:
Please go to control section -> system -> DEVICE MANAGER -> advance -> COM connecting number,
please
select one.
Then go to the tool bar of MAXIEDITOR -> Choose "OPTION -> USB to COM" and select the right COM.
Then it should be ok to link.