3.2 The Rear Panel
21
22
19
18
17
20
16
15
6
19. Headphone Out1
20. Headphone Out2
21. Headphone Out3
22. Headphone Out4
17. Main Input Connectors
These connectors are used to input the stereo signal. You can input the main signal via the balanced 1/4" TRS
phone jack or XLR connector.
18. Main Output Connectors
TRS phone jack or XLR connector. In some typical field, you can also use these connectors to interlink several
Headphone Amplifiers for more groups monitor.
16. AC Inlet
After the correct voltage has been set you can connect the AC plug to the unit and in the AC power socket.
15. Fuse holder / Voltage selector
Please note the triangular markers on both sides of the fuse holder ( See figure above), To change the voltage pull
the fuse holder out, rotate it 180 and push it back again. The operating voltage will be that indicated by one of the
two triangular markers.
THIS IS SET FOR
110V AC TO 120V
AC OPERATION
THIS IS SET FOR
220V AC TO 240V
AC OPERATION
You must be sure of the Voltage available in your Country because this is a Dual Voltage Unit. Voltage opera-
tion can be changed through the fuse protecting the power supply but this operation must be performed by a
qualified Engineer.
220-240V
110-120V
110-120V
220-240V
MAIN INPUT LEFT
MAIN INPUT RIGHT
MAIN OUTPUT RIGHT
MAIN OUTPUT LEFT
HEADPHONE OUT 4
HEADPHONE OUT 3
HEADPHONE OUT 2
HEADPHONE OUT 1
TIP:L- CHANNEL
RING:R- CHANNEL
MIN. LOAD 100OHMS
AC INPUT
95-120V
/210-240V
60-50Hz
Rated Power Consumption 40W
FUSE:
210-240V: T200mAL 250VAC
95-120V: T315mA 250VAC
REPLACE FUSE WITH CORRECT
TYPE ONLY
Apparaten skall anslutas till
jordat uttag nar den ansluts
till ett natverk
A101
TIP/PIN 2
RING/PIN 3
SLEEVE/PIN 1
TIP/PIN 2
RING/PIN 3
SLEEVE/PIN 1
TIP/PIN 2
RING/PIN 3
SLEEVE/PIN 1
TIP/PIN 2
RING/PIN 3
SLEEVE/PIN 1
11
0-120V
220-240V
PUSH
2
1
3
NEW
TIDE
PUSH
2
1
3
NEW
TIDE
These connectors are used to output the stereo signal. You can output the main signal via the balanced 1/4"
In Parallel with the Headphone Out on the front panel (for Channel 1), these are the headphone outputs of
Channel 1.
In Parallel with the Headphone Out on the front panel (for Channel 2), these are the headphone outputs of
Channel 2.
In Parallel with the Headphone Out on the front panel (for Channel 3), these are the headphone outputs of
Channel 3.
In Parallel with the Headphone Out on the front panel (for Channel 4), these are the headphone outputs of
Channel 4.
