6. Level Control for Channels 1&2
These two controls are used to adjust output level of channel 1 and channel 2 respectively.
7. UP/DOWN Key
This key is used to move inside the menus or to modify the parameter's value.
8. SELECT Key
This key is used to select the menu that you wish to edit.
9. ENTER Key
This key is used to edit or confirm the parameter's value.
11. Power Source Socket
It is used to connect power cord after setting the proper voltage, connect one end of power cord with the unit
and another end with mains.
12. Breaker
This switch functions as fuse for protecting the unit from damage. When the unit is overloaded or the
temperature inside the unit is too high, this pushing button will spring up and break the power supply. The
power supply will be recovered after pushing this switch down again.
13. Output Connector
These connectors have two kinds: Binding post and Speak-on connector. You can choose proper connectors
according to practical need. For your safety, please be careful when do connecting work.
14. Limiter Switch
Set this switch at "ON" position, once the output level is above maximum output level, the limiter begins,
thus keeping consistent output level for protecting apparatus. If the switch is set at "OFF", the limiter function
doesn't work.
3.2 Rear Panel
These connectors connect the input signal of channel 1 and channel 2 separately.
15. Balanced Input Connectors
These two output connectors are paralleled inside with the two input connectors. It enables the unit to work under
paralleled mode. Please also refer to wiring diagram for paralleled mode.
16. Parallel Output Connectors
17. Mode Selector
Total two optional modes: Up for Stereo mode; Down for Bridge mode.
- Stereo Mode
In this mode, channel 1 and channel 2 operate independently (just as traditional stereo amplifier). The signal
input into channel 1 can be output from channel 1 only, similarly, the signal input into channel 2 can be output
from channel 2 only.You can also operate the paralleled mode via outside wiring, so, the signal input from
channel 1 or 2 will be output from both channel 1 and 2 simultaneously. Details refer to the chapter 9.
- Bridge Mode
In this mode, the signal input into channel 1 will be output from the bridged end, on the other hand, the
output level control of channel 2 should be turned down to smallest.Details refer to the chapter 9.
5
The fan can accelerate the flow of air to lower the temperature inside unit.The inside temperature deter-
the fan speed which controls the inside air flowing speed.
mines
10. Fan
20
12
19
18
15
11
13
15
16
17 14
Apparaten skall anslutas
till jordat uttag nar den
ansluts till ett natverk
RS485 IN
RS485 OUT
RS232
SERIAL PORT
BREAKER
CH1
CH2
BRIDGE
MONO
OUTPUT2
OUTPUT1
POWER OUTPUTS
CH1
1+
1-
POS NEG
CH2
2+
2-
POS NEG
BRIDGE
1+
2+
POS NEG
CH2
1+
1-
POS NEG
MODE
BRIDGE
STEREO
LIMITER
OFF
ON
PARALLEL
OUTPUT
PARALLEL
OUTPUT
TIP/PIN 2
RING/PIN 3
SLEEVE/PIN 1
TIP/PIN 2
RING/PIN 3
SLEEVE/PIN 1
CH1
CH2
SERIAL
MODEL
2
1
3
2
1
3
