Alto Clarke Vision 17E, Руководство оператора

Страница: 67 / 85

Page -20- CLARKE TECHNOLOGY Operator's Manual -Vision 17E 230V
There isn't any solution flow. The solution tank is empty. Fill the solution tank.
The solution knob is turned too far to the left. Turn the solution knob to the right.
There is an obstruction in the hose or filter. Remove the obstruction from hose or filter.
The solution valve or linkage is damaged. Repair or replace the valve or the linkage.
The solution flow does not stop. The solution valve is open. Close the solution valve.
The solution valve or linkage is damaged. Repair or replace the valve or the linkage.
The solution valve is dirty. Clean the solution valve.
There is a damaged seat and washer
in the solution valve. Replace the valve.
The valve steam is dirty. Clean and lubricate the valve stem.
The machine does not remove The squeegee is up. Lower the squeegee.
any water from the floor. The vacuum motor is not running. Put the switch in the "ON" position.
The vacuum motor switch is defective. Have an authorized Clarke person make
repairs.
The recovery tank is full. Drain the tank.
The vacuum shut-off float circuit is open. Recovery tank is full. Empty the tank.
The vacuum filter screen is dirty. Clean or replace the filter screen.
There is an obstruction in the vacuum tube. Remove the obstruction.
There is an obstruction or damage in the Remove the obstruction or repair the
squeegee, vacuum hose or standpipe. damage.
The squeegee hose is disconnected. Connect the hose.
The machine does not remove The squeegee blades are damaged, worn, Turn or replace the squeegee blade.
all the water from the floor. or incorrectly installed. Correctly install the squeegee blade.
There is an obstruction or damage in the Remove the obstruction or repair the
squeegee, vacuum hose or standpipe. damage.
The filter screen is dirty. Clean or replace the filter screen.
The gasket on the cover of the recovery Replace the gasket.
tank are damaged.
Defective vacuum motor. Have an authorized Clarke person make
repairs.
The cleaning is not even. The scrub brush or pad are worn. Replace the scrub brush or pad.
There is damage to the brush assembly Have an authorized service person
casters or to the solution valve. make the repairs.
The motor is not running. Repair the wiring, replace the switch,
Service the motor, circuit breaker
and the contractor.
HOW TOO CORRECT PROBLEMS IN THE MACHINE
P
ROBLEM
C
AUSE
A
CTION