Alto-Shaam 1200-UP Series, Установка, эксплуатация и обслуживание

Страница: 20 / 40

1200-S, 1200-UP •
INSTALLATION
/
OPERATION
/
SERVICE MANUAL
-
PG
. 19
D A N G E R
DISCONNECT UNIT FROM
POWER SOURCE BEFORE
CLEANING OR SERVICING.
C A U T I O N
THIS SECTION IS PROVIDED FOR THE ASSISTANCE
OF QUALIFIED SERVICE TECHNICIANS ONLY AND
IS NOT INTENDED FOR USE BY UNTRAINED OR
UNAUTHORIZED SERVICE PERSONNEL.
No. 4878 for all except 4000W cabinets
INCLUDES
:
CB-3045 Cable Heating Element . .85 feet (2591cm)
CR-3226 Ring Connector . . . . . . . . . . . . . . . . . . . .4
IN-3488 Insulation Corner . . . . . . .1 foot (30,5cm)
BU-3105 Shoulder Bushing . . . . . . . . . . . . . . . . . .4
BU-3106 Cup Bushing . . . . . . . . . . . . . . . . . . . . . .4
ST-2439 Stud . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
NU-2215 Hex Nut . . . . . . . . . . . . . . . . . . . . . . . . . .8
SL-3063 Insulating Sleeve . . . . . . . . . . . . . . . . . . .4
TA-3540 Electrical Tape . . . . . . . . . . . . . . . . .1 roll
No. 4881 for 4000W cabinets
INCLUDES
:
CB-3045 Cable Heating Element .210 feet (6401cm)
CR-3226 Ring Connector . . . . . . . . . . . . . . . . . . . .12
IN-3488 Insulation Corner . . . . . . . .1 foot (30,5cm)
BU-3105 Shoulder Bushing . . . . . . . . . . . . . . . . . .12
BU-3106 Cup Bushing . . . . . . . . . . . . . . . . . . . . . .12
ST-2439 Stud . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12
NU-2215 Hex Nut . . . . . . . . . . . . . . . . . . . . . . . . .24
SL-3063 Insulating Sleeve . . . . . . . . . . . . . . . . . .12
TA-3540 Electrical Tape . . . . . . . . . . . . . . . . . .1 roll
CABLE HEATING SERVICE KIT
(
O N E K I T P E R C A BI N E T C O M PA RT M E N T
)
S E R V I C E
T R O U B L E S H O O T I N G - M A N U A L C O N T R O L
Error
Code
Description/Results Possible Cause
E-10 Air Sensor Shorted
Inoperative Unit
Defective sensor or damaged sensor connection.
E-11 Air Sensor Open
Inoperative Unit
Defective sensor or poor sensor connection.
E-30 Under temperature
Cavity has been under its set
temperature for 90 minutes.
Oven will not reach set temperature
Door gasket damaged or door left open.
Pre-heat skipped before loading the oven.
Loading the oven with frozen product.
Defective sensor or poor sensor connection.
Defective solid state relay.
Defective heater element.
E-31 Over temperature
Unit has exceeded its maximum
allowable set temperature by
25 degrees.
Unit will shut down
Defective sensor or poor sensor connection.
Defective solid state relay.
Shorted heater element.
E-70 Configuration error
Inoperative Unit
Contact Alto-Shaam Service Department.
E-82
or
E-83 EEPROM - Calibration data error
Inoperative Unit
Contact Alto-Shaam Service Department.
E-90 Button shorted
Inoperative Control
Stuck button on control panel. Check buttons.
If control is still inoperative, contact Alto-Shaam Service Department.
E-91 Input failure
Contact Alto-Shaam Service Department.