I N S T A L L A T I O N A N D I N S T R U C T I O N M A N U A L
4
SETUP AND INSTALLATION
Unpacking
Remove the SS-CYC-100 lighting fixture from its shipping box. Set the unit down on a flat surface before
proceeding.
Lamping and Re-lamping
The SS-CYC-100 lighting fixture is provided with an integral LED light engine. Under normal operating
conditions, the LED light engine should have a rated life expectancy of over 50,000 hours. There are no user
serviceable parts inside. The entire LED assembly will need to be changed.
Mounting the fixture
For Sky-Cyc ceiling mounting: Install the Yoke kit and a Pipe Clamp if desired. Loosen the bolt on the pipe
clamp mounted on top of the fixture yoke until the clamp fits snugly around the mounting pipe. Make sure the
clamp wraps securely around the pipe surface. Tighten up the bolt securely to the pipe. Next, loop the safety
cable around the pipe and yoke, and then clip it back onto the cable itself. For floor mounting: Lay the unit
on a flat leveled surface and adjust the rubber feet to the desired tilt angle. The fixture yoke is not needed for
Ground-Cyc applications.
Connecting power to the fixture
Plug the fixture into a properly grounded receptacle connected to a circuit breaker.
Focusing the fixture
With the fixture energized, point the unit in the direction of the object to be illuminated. Adjust the yoke or
feet to the desired position. The optimum distance for best results is 4 to 5 feet away from the projection
surface.
Cleaning the fixture
Routine cleaning of the SS-CYC-100 lighting fixture will provide years of prolonged use. Use compressed air to
blow off any dust and dirt from the lens, reflector, electronics and heat sink. For the lens, use a soft lint-free
cloth dampened with water to clean the lens of dust and dirt. Dry off completely with compressed air or a dry
lint-free cloth.
ETL FILE LISTING
The SS-CYC-100 lighting fixture is ETL and c-ETL listed under Altman File 9700680 for Portable Electric
Luminaires.
